Square shank holder

Overview of the technical facts:

Internal coolant supply straight to the cutting edge
Coolant connections left, right, rear and bottom
High flexibility, can be used in all VDI basic holders
Improved chip flow

Send request

Square shaft holder for exchangeable insert type PWP s=5, insertion angle 8°

With internal coolant supply straight to the cutting edge
With 3 coolant connections (rear, left, right)
Additional coolant transfer from below (bore Ø5 + elongated hole)
Shaft cross-section 16 x 16 - 25 x 25

Square shaft holder for exchangeable insert type PWP s=5, insertion angle 0°

With internal coolant supply straight to the cutting edge
With 3 coolant connections (rear, left, right)
Additional coolant transfer from below (bore Ø5 + elongated hole)
Shaft cross-section 12 x 12 - 25 x 25

Square shaft holder for exchangeable insert type PWP s=5, insertion angle 8°

With internal coolant supply straight to the cutting edge
With 3 coolant connections (rear, left, right)
Additional coolant transfer from below (bore Ø5 + elongated hole)
Shaft cross-section 16 x 16 - 25 x 25

Square shaft holder for exchangeable insert type PWP s=3 or s=5

Design according to customer requirements

Square shaft holder for insert type WEP 12.10 / 14.40 / 19.05 / 23.60 / 30.60

Right or left version
Shaft cross-section 12 x 12 - 25 x 25

Similar applications

[Translate to US Englisch:]

Modular System MSIK

Customer-specific solutions